The most correct modification solution for Trumpchi GA 8 audio: German 0.3-point six-channel power amplifier active gameplay
German zero point RC 165.3 SQ ATC series three-way frequency has extremely high cost performance, low power and high sensitivity. All series of units are designed with 3 ohm impedance, which can best restore the sound performance and achieve the excellent performance of thick intermediate frequency and good treble extension. Moreover, the power requirement of the power amplifier is very low, and the power loss of the vehicle is much smaller, which is required by a major trend of car audio modification at present.
This Chuanqi GA 8 has been modified with a simple two-way system earlier, which is matched with the “Sound of Berlin” with four-door speakers, other brands of power amplifiers and dsp, and it is always difficult to meet the listening requirements of car owners.
The modification scheme we recommend this time is:
Host: Original vehicle
Audio Processor: Magic Cube dsp-8 + 5 V
Front Soundstage: German zero point RC 165.3 SQ ATC
Super bass: German zero point 10-inch original box
Speaker amplifier: Magic Cube Six Channel E 600
Bass amplifier: Comes with (previously modified power amplifier)
Wire: standard configuration
The bass in the picture below is the 10-inch Rambler modified by the owner before. After comparing it with the zero-point 10-inch super-bass audition, the owner finally chose the zero-point bass. Relatively speaking, the effect advantage is obvious, the zero-point bass dive is better, and the bass is very clean and elastic.
When I disassembled the door panel, I found that the previously modified sound insulation stickers did not meet the standards of our store and had to be reinstalled. The picture below is a comparison before and after the modification.
Renderings of the completed installation of the front door zero-point mid-bass
This is the treble and midrange inverted modification on the A-pillar. The A-pillar modification is very midrange, which is related to the sound field, pointing and positioning. Every step of car audio modification is very particular. This is not a fantasy, it is our accumulation of years of modification experience.
Process details of modified A-pillar
The Magic Cube dsp and six-channel power amplifier are installed under the main driver’s seat.
This power amplifier independently drives the subwoofer and is installed under the passenger seat.
Installation of system power supply safety.
Debugging is completed, the vehicle is cleaned, and it is ready for delivery.
